Stain Removing Protocol - Exosomal Liquid Laser

Preparation at home:
The patient prepares the skin at least 1 week before treatment:
-Morning and evening: Apply GF20 Exosome Boost.
-Evening: Apply H8 Night Serum, followed by GF20 Boost after 30 minutes.

Treatment in a clinic:

1. preparation:
- Clean the skin and remove impurities.
- Apply anesthetic cream for 30 minutes and disinfect the skin.
- Lower skin pH with PH Prep Solution for better absorption of active ingredients.

2. application of active solutions:
- Apply 1.5 ml of Radiance Bio Booster in micro-doses and massage in.
- Add 0.5 ml of Cell Renew to the same syringe of Radiance and massage for a further 2 minutes.

3. microneedling and peeling:
- Leave the peeling solution on the skin and perform microneedling with 0.5 mm needle depth.
- If necessary, apply an additional layer of peeling and massage until the pain level reaches a maximum of 7 on a scale of 1-10.

4. Neutralization and recovery:
- Neutralize with Neutralizer and remove residue with sterile compress moistened in physiological solution.
- Apply 2.5 ml of Purasomes SGC 100+ to soothe the skin and promote healing.
- Finish with GF20 Exosome Boost Cream to relieve irritation and moisturize the skin.

Aftercare at home:
-Morning and evening: continue with GF20 Exosome Boost to support skin healing.
-Evening: Complete with H8 Night Serum followed by GF20 Boost.
-Protection: Use SPF daily to protect skin and prevent pigmentation changes.

Results:
The Stain Removing Protocol reduces hyperpigmentation, evens out skin tone and deeply moisturizes. The treatment is effective against dark spots, sun damage and post-inflammatory hyperpigmentation (PIH).

Recommendation: 3-4 treatments at 2-4 week intervals for best results.